Pittock A.B., 2nd ed., Climate change the science, impacts and solutions, CSIRO, 2009.
 EG and G Technical Services, Inc. Science Applications International Corporation, 6th ed., Fuel Cell Handbook, US Department of Energy, 2002.
 Ghassemi M., Kamvar M. and Steinberger-wilckens R., 1st ed., Fundamentals of heat and fluid flow in high temperature fuel cells, Elsevier, 2020.
 Bove R. and Ubertini S., 1th ed., Modeling Solid Oxide Fuel Cells, Methods, Procedures and Technologies, Springer, 2008.
 Kupecki J., Papurello D., Lanzini A., Naumovich Y., Motylinski K., Blesznowski M and Santarelli M., “Numerical model of planar anode supported solid oxide fuel cell fed with fuel containing H2S operating in direct internal reforming mode (DIR-SOFC)”, J. Applied Energy, 2018, 230: 1573.
 Kim S., Jang I., Kim Ch., Lee H., Song T., Yoon H. and Paik U., “Enhanced reliability of planar-type solid oxide fuel cell stack incorporating leakage gas induction channels”, Int. J. Hydrogen Energy, 2020, 45: 11834.
 Hibino T. and Iwahara H., “Simplification of solid oxide fuel cell system using partial oxidation of methane”, Chemistry Letters, 1993, 22: 1131.
 Tian Y., Wu P., Zhang X., Guo X. and Ding L., “Performance of a linear array solid oxide fuel cell micro-stack operated in single-chamber conditions” J. Ionics, 2020, 26: 6217.
 Kamvar M., Ghassemi M. and Rezaei M., “Effect of catalyst layer configuration on single chamber solid oxide fuel cell performance”, J. Applied Thermal Engineering, 2016, 100: 98.
 Kamvar M., Ghassemi M. and Steinberger-Wilckens R., “The numerical investigation of a planar single chamber solid oxide fuel cell performance with a focus on the support types”, Int. J. Hydrogen Energy, 2020, 45: 7077.
 Tian Y., Lu Zh., Wang Zh., Wei B., Nie Zh. And Zhai A., “Enhanced performance of a single-chamber solid oxide fuel cell with dual gas supply method”, Ionics, 2019, 25: 1281.
 Bedon A., Viricelle J.P., Rieu M., Mascotto S. and Glisenti A., “Single chamber solid oxide ful cells selective electrodes: A real chance with brownmillerite-based nanocomposites” Int. J. Hydrogen Energy, 2021, 46:14735.
 Akhtar N., Decent S. P., Loghin D. and Kendall K., “A three dimensional numerical model of a single-chamber solid oxide fuel cell”, Int. J. Hydrogen Energy, 2009, 34: 8645.
 Akhtar N., Decent S. P., Loghin D. and Kendall K., “Mixed-reactant, micro-tubular solid oxide fuels: An experimental study”, J. Power Sources, 2009, 193: 39.
 Akhtar N. and Kendall K., “Micro-tubular, solid oxide fuel cell stack operated under single-chamber conditions”, Int. J. Hydrogen Energy, 2011, 36: 13083.
 Akhtar N., Decent S. P. and Kendall K., “Numerical modelling of methane-powered micro-tubular, single-chamber solid oxide fuel cell”, J. Power Sources, 2010, 195: 7796.
 Akhtar N., Decent S. P. and Kendall K., “A parametric analysis of a micro-tubular, single-chamber solid oxide fuel cell (MT-SC-SOFC)”, Int. J. Hydrogen Energy, 2011, 36: 765.
 Akhtar N., “Micro-tubular, single-chamber solid oxide fuel cell (MT-SC-SOFC) stacks: Model development”, Chemical Engineering Research and Design, 2012, 90: 814.
 Akhtar N., “Modeling of novel porous inserted micro-tubular, single-chamber solid oxide fuel cells (MT-SC-SOFC)”, Chemical Engineering Journal, 2012, 179: 277.
 Kamvar M. and Ghassemi M., “Performance analysis of coplanar single chamber solid oxide fuel cell with oxygen-methane-nitrogen mixture under steady state conditions”, J. Modares Mechanical Engineering, 2017, 17: 31
 Guo Y.M., Bessaa M., Aquado S., Cesar Steil M., Rembelski D., Rieu M., et al., “An all porous solid ocide fuel cell (SOFC): a bridging technology between dual and single chamber SOFCs”, Energy Environ. Sci., 2013, 6: 2119.
 Guo Y.M., Largiller G., Guizard C., Tardivat C. and Farrusseng D., “Coke-free operation of an all porous solid oxide fuel cell (AP-SOFC) used as an O2 supply device”, J Materials Chemistry A, 2015, 3: 2684.
 Xu H., Chen B., Tan P., Cai W., He W., et al., “Modelling of all porous solid oxide fuel cells”, Applied Energy, 2018, 219: 105.
 Xu H., Chen B., Tan P., Xuan J., Mercedes M., et al., “Modelling of all-porous solid oxide fuel cells with a focus on the electrolyte porosity design”, Applied Energy, 2019, 235: 602.
 Xu H., Chen B., Tan P., Zhang Y., He Q., et al., “The thermal effects of all-porous solid oxide fuel cells”, J. Power Sources, 2019, 440: 227102.
 Kamlungsua K., Su P. C. and Chan S. H., “Hydrogen generation using solid oxide electrolysis cells”, Fuel cells, 2020, 6: 644.
 M. Kamvar, “Comparative numerical study of co- and counter-flow configurations of an all-porous solid oxide fuel cell”, Iranian J of Hydrogen & Fuel Cell, 2021, 2: 77.
 Timurkutluk B., Celik S., Timurkutluk C., Mat M.D. and Kaplan Y., “Novel electrolytes for solid oxide fuel cells with improved mechanical properties”, Int. J. Hydrogen Energy, 2012, 37: 13499.
 Nield D.A. and Bejan A., 3rd ed., Convection in Porous Media, Springer, 2006.
 Batchelor G.K., 1st ed., An Introduction To Fluid Dynamics, Cambridge University Press, 2000.
 Taylor R. and Krishna R., 1th ed., Multicomponent mass transfer, John Willey & Sons, Inc., 1993.
 Cengel Y.A. and Ghajar A. J., 5th ed., Heat and mass transfer fundamentals & applications, MC Graw Hill, 2014.