Performance assessment of a SOFC cogeneration system for residential buildings located in eastern Iran

Document Type : Research Paper


1 Birjand University faculty member

2 Water and sewer employees of Birjand


It is expected that residential units may replace   traditional heat and power production systems with cogeneration ones. Among the different cogeneration systems, fuel cell based systems are a suitable choice due to their high efficiency, high power density, low emission and low noise. In this paper, a cogeneration system based on solid oxide fuel cells is examined. The system, including the fuel and air compressors, desulphurizer,  fuel reformer, fuel cell stack,   etc.,   has been modeled from an energy and exergy viewpoint.   An optimization algorithm with three different objective functions, including power production, heat production and the minimum exergy destruction, is applied. Then, the base system is utilized along with photovoltaic and electrolizer as a combined system. The results showed that an OP (Ordinary + Photovoltaic) is the best configuration with emissions reduction in the heat production approach, while   OP and OFPE (Ordinary + Fuel cell + Photovoltaic + Electrolizer) configurations are the best configurations with excess energy in power production approach. The conditions of the numerical calculations were selected in accordance with a sample building located in eastern   Iran.


Main Subjects

[1]Office, E.a.E.P., Energy Balance in 2009 and 2010, Energy Ministry: Tehran.
[2]Onovwiona H.I. and Ugursal V.I., "Residential cogeneration systems": review of the current technology. Renewable and Sustainable Energy Reviews, 2006, 10: 389.
[3]Hasanzadeh H. and Mansouri S.H., "Efficiency of ideal fuel cell and carnot cycle from a fundamental prospective". Journal of Power and Energy, 2005, 219: 245.
[4]Hassanzadeh H. and Farzad M.A., "Combined Fuel Cell and Photovoltaic System Assessment for CHP in House", 4th Fuel Cell Seminar 2010: Tehran- Iran.
[5]Rosen M.A. and Scott D.S., "A Thermodynamic Investigation of the Potential for Cogeneration for Fuel Cells", International Journal of Hydrogen Energy, 1988, 13: 775.
[6] Hussain M.M., Dincer I., and Li X., "Energy and Exergy Analysis of an Integrated SOFC Power System", CSME Forum, 2004, 1.
[7]Rohani S. and Najafi A.F., "Thermodynamic Analysis of Solid Oxide Fuel Cell and Gas Turbine Combined Systems via Exergy", 25th International Power System Conference 2010: Tehran.
[8]Lee K.H. and Strand R.K., "A System level Simulation Model of SOFC Systems for Building Applications", Third National Conference of IBPSA2008: Berkeley, California, USA.
[9]Lee K.H. and Strand R.K. , "SOFC cogeneration system for building applications, part 1: Development of SOFC system-level model and the parametric study", Renewable Energy, 2009, 34: 2831.
[10]Lee K.H. and Strand R.K. , "SOFC cogeneration system for building applications", part 2: System configuration and operating condition design, Renewable Energy, 2009, 34: 2839.
[11]Bompard E., Napoli R., Wan B. and Orsello G., "Economics evaluation of 5kW SOFC power system for residental use", Int. Journal of hydrogen energy, 2008,33:3243.
[12]San B. G., Zhou P. L. , and Clealand D., "Dynamic Modeling of Tubular SOFC for Marine Power System". Journal of Marine Science and Application, 2010, 9: 231.
[13]Lamas H., Shimizu J., Matsumura E. and Senda J., "Fuel consumption analysis of a residential cogeneration system using a solid oxide fuel cell with regulation of heat to power ratio", Int. Journal of Hydrogen Energy, 2013, 38:16338.
[14]Hosseini M., Dincer I. and Rosen M. A., "Hybrid solar-fuel cell combined heat and power systems for residential applications", Energy and exergy analyses, J. Power Source, 2013, 221: 372.
[15] Farzad M.A., Hassanzadeh H., "Modeling and optimization of a single planar solid oxide fuel cell", Modares Mechanical Engineering, 2015, 15: 81 (In Persian).
[16] O'Hayre R.P., Cha Suk-Won, Colella W. and Printz Fritz B., "Fuel Cell Fundamentals", 2009, John Wiley & Sons.
[17]Lysholm Corporation, 2012, Available from:
[18]Singhal, S.C. and Kendall K., "High Temperatures Solid Oxide Fuel Cells" Fundamentals, Design and Application, 2003: Elsevier.
[19] Braun R. J., "Optimal design and opration of solid oxide fuel cell systems for samll-scale stationary applications", 2002, PhD thesis, university of Wisconsin.
 [20]Aguiar, P., Adjiman C.S., and Brandon N.P., "Anode-supported intermediate temperature direct internal reforming solid oxide fuel cell. I: model-based steady-state performance. Journal of Power Sources, 2004, 138: 120.
[21]Iora P. , Aguiar P., Adjiman C.S.,  Brandon N.P., "Comparison two IT DIR-SOFC models": Impact of variable thermodynamic, physical, and flow properties. Steady-state and dynamic analysis. Chemical Engineering Science, 2005, 60: 2963.
[22]Kang Ying-Wei, Li Jun , Cao Guang-Yi , Tu Heng-Yong , Li Jian , Yang Jie,  "A reduced 1D dynamic model of a planar direct internal reforming solid oxide fuel cell for system research". Journal of Power Sources, 2009, 188: 170.
[23]Aguiar, P., Adjiman C.S., and Brandon N.P., "Anode-supported intermediate-temperature direct internal reforming solid oxide fuel cell" II. Model-based dynamic performance and control. Journal of Power Sources, 2005, 147: 136.
[24] "gPROMS Model Developer Guide", 2011, Process Systems Enterprise: London.
[25] "gPROMS ModelBuilder Guide", 2011, Process Systems Enterprise: London.
[26] "gPROMS Optimisation Guide", 2011, Process Systems Enterprise: London.
[27] Duffie, J.A. and Beckman W.A., "Solar Engineering of Thermal Processes". 2nd Edition 1980: John Wiley & Sons.
[28] Suntech Power Company. Available from:
[29] Bilgen, E., "Domestic hydrogen production using renewable energy". Solar Energy, 2004, 77: 47.
[30] ITM Power Corporation. Available from:
[31] RETScreen, Natural Resources Canada.